Product image for illustration purposes only. Whilst every care is taken to provide accurate images of our products, actual products may differ slightly.
This is a very stable casting-mould, heat-resistant up to 120°C.
Material: polycarbonate.
After cooling, the formed candle is easily removed from the mold. If necessary, the candle together with the mold can be placed in the freezer for a short time.
The content: candle casting mould, wick, special needle for wicks, fixing clamps, sealing rubber, precise instruction manual.
In order to demould this round candle from the mould, the mould consists of two parts which are firmly held together by means of fixing clamps and sealing rubber when the liquid wax is poured in.
Instructions for use:
1) Make sure the candle mold is clean and dry.
2) Tie a double knot at one end of the wick and cut the required length. Pass the wick from the outside in through the small hole in the mold. Attach the free end of the wick to a stick or needle and cross it across the template.
3) Melt the wax in a water bath (approx. 80°C), mix thoroughly and carefully pour into the mold.
* If you use pieces of old candles for melting, they must be cleaned thoroughly (remove the old candle wick). If lumps have formed when melting the old candles, pour the wax through a sieve.
4) The melted wax should be carefully poured in small amounts several times so that funnels do not form due to rapid cooling. Allow the wax to harden completely and cut the double knot before removing the candle from the mold.
5) Wash the mold with hot water and wipe with a paper towel.
Sign up and be the first to receive information
about news and special offers
